Pregnancy test strip Dr.Marta No. 2

Dr. Marta is a new TM, presented on the Ukrainian market with pregnancy and ovulation tests. The distinctive features of Dr. Marta products are high accuracy, confirmed by laboratory research, as well as maximum sensitivity of the tests.

Dr.Marta pregnancy and ovulation tests are easy and convenient to use at home.

Maximum sensitivity up to 10 μIU/ml. High accuracy – up to 99.9% of reliable results. Wide test strip - 4.5 mm - increases detection accuracy compared to narrower strips. Early detection – 5-7 days before the delay.

How to use

Remove the test strip from the sealed package and perform the test immediately. Holding the test strip vertically, lower it into the container with the urine sample so that the arrows point downwards. Do not lower the strip below the MAX line (maximum), indicated by the arrows on the test strip. After 5 seconds, remove the strip from the container and place it on a clean, dry surface. Wait for the colored lines to appear.

The result should be evaluated no earlier than 5 minutes and no later than 10 minutes.

Interpretation of results

Negative result: The presence of 1 colored line in the control region of the rapid test and no line in the result region means that the test result is negative, no hCG was detected in the urine. This means that you are either not pregnant or you tested too early. If you are not sure, repeat the test after 48 hours.

Positive result: The presence of two colored lines on the rapid test (one in the result zone and one in the control zone) means that you are most likely pregnant. HCG is detected in your urine. One line may be lighter than the other. They do not have to be the same color. This in any case means a positive test result.

Invalid test: The absence of colored lines in the result and control lines indicates that the result is invalid. The test should be repeated with a new test strip.

Storage conditions

Store in the original packaging at a temperature not exceeding 25 °C.

Packaging

2 test strips per package.

Producer

Kor Technology CO., LTD.

Address and location of the manufacturer

Room 100, Building C, NO.29 Life Park Road. Changping District, Beijing 10220 People's Republic of China.